How do I assemble the Urban Iki balance bike?

Place the handlebar into the bike frame. Make sure the vertical stripes are fully inside the frame and the handlebar is parallel to the front weld. Tighten the bolt on top of the handlebar. Then, check if the second bolt under the handlebar is secure.

Place the seat into the bike frame. Make sure the vertical stripes are fully inside the frame. Then, tighten the seat with the Allen key.

Insert the two white bushings on both sides of the wheel. Determine the height of the bike: use the top hole(s) for younger children and the bottom hole(s) for older children.

Place the wheel between the fork at the chosen height and insert the axle through the selected hole and wheel. Place a washer, spring washer, and nut on both sides of the axle. Tighten the nuts using two wrenches.

Repeat steps 3 and 4 to install the rear wheel. Adjust the height of the bike: use the top hole(s) for younger children and the bottom hole(s) for older children.

Now that the balance bike is assembled, adjust the handlebar and seat to the correct height using the Allen key.

Note! The vertical stripes on the handlebar and seat indicate the maximum height for both. The stripes should not be visible.

If the seat cannot be raised any higher, adjust the height of the wheel axles.