How do you mount the Urban Iki front seat with the ICR Adapter Acros?

Use your bike’s tools to remove the cover cap, for example, with an Allen wrench.

Next, loosen the two horizontal bolts. They don’t need to be removed completely.

Tilt the handlebar forward to reveal the nut. Use an Allen key to fully loosen the bolt at the bottom.

Next, loosen the two horizontal bolts. These need to be removed completely.

Carefully remove the handlebar from the stem. Let it hang down gently with the shifter cables. Remove all spacers from the stem.

While carefully guiding the cables into the designated grooves, slide the clamp ring onto the stem. You will hear a click when the clamp ring fits properly onto the stem.

Remove the cover from the adapter. Guide the cables through the adapter into the designated slots and slide the adapter on top of the clamp ring. It will only click into place in one correct way, so pay close attention to this.

Place the handlebar back onto your bike and install the cover. Tighten it securely by fastening the bolt at the top of the stem, the two horizontal bolts, and the bolt at the front of the clamp ring. Ensure that the metal bolt is fully inserted into the handlebar. When tightening, make sure to keep the handlebar straight.

Tilt the handlebar back up and secure it by tightening the two bolts.

Place the cover back onto the stem and tighten it with the bolt.

Slide the included bracket over the front of the adapter. Secure it by tightening the ring and bolt at the two spots. The bracket is now firmly mounted, ready to attach the windscreen.

If you’re not installing a windscreen, simply reinstall the cover onto the front of the adapter.

Take the Urban Iki front seat and, at the bottom of the seat, pull the tab down while pulling the part you’re holding towards you. Slide the seat onto the ICR adapter Acros until you hear a ‘click’. Then, check to make sure the seat is securely attached.