Nederland/België
United Kingdom
Deutschland
Danmark
Take the two leg protectors and slide them into each other until they are tightly locked. Then lay the rear seat on its back, let the cable dangle and slide the leg sections into the slots on either side of the rear seat until you hear a ‘click’. This means the leg protectors are firmly attached.
Use the Allen wrench to loosen the mounting frame hooks. This allows you to move them and make the frame fit your luggage rack. Make sure to install the frame lengthwise on your luggage carrier.
Make sure that the open part of the mounting frame is positioned exactly above the axle of your back wheel.
Use the allen wrench to tighten the hooks of the mounting frame (clockwise). This firmly attaches the frame to the luggage carrier of your bicycle.
Great, the mounting frame is now firmly attached to your luggage carrier. Take the rear seat for the most important step: attaching the Urban Iki rear seat to your bike.
Easily set a personal security code for the lock. First enter the code ‘000’. Open the lock and then press and hold the bottom of the lock; then set your personal three-digit code and release the bottom. Now you have set up your personal code! To open the lock, enter your personal code, press the two sides and disconnect the cable.
Wrap the cable of the lock around the seat tube of your bicycle. To close the lock, insert the cable into the lock until you hear a ‘click’. This means it’s tightly locked!
You can detach the rear seat in two simple steps. This allows you to leave the seat at home when you are going out without mini-me.
Enter your personal security code and press the two sides of the lock. Next, disconnect the cable and release it from the frame tube. Then click the lock back together so that the two parts are not dangling.
Hold the lock and the 5-point belt in one hand. Pull the clip downwards and the disc at the bottom backwards with your other hand. This allows you to remove the seat in one fluid movement. Easy as 1, 2, 3!
