How do I mount the Urban Iki rear seat with frame mounting?

For this, you’ll need the two leg parts, along with the Urban Iki rear seat. Slide the two leg parts together so they are securely attached. Then place the rear seat on its back, hang down the safety strap, and slide the leg parts into the grooves on either side of the rear seat. Make sure you hear a ‘click’. This indicates that the leg parts are securely in place.

First, place a washer around each bolt (four in total) and make sure the covers under the mounting block are closed. Then insert the bolts into the four designated holes on the top of the mounting block.

Place a dowel over the bolts and determine the correct height for the frame block by holding the bracket next to it. The frame should extend above the wheel. Tighten the bolts (clockwise) with the Allen key.

Slide the cover onto the mounting block (from top to bottom) until you hear a ‘click’.

Now that the mounting block is securely attached to the frame of your bicycle, you can insert the frame bracket into the mounting block. Place the bracket in the designated holes on the backside. Please note: only when you hear a clear ‘click’, the frame mounting bracket is securely in place!

Use the Allen wrench to loosen the hooks on the mounting frame. After loosening, you can slide the holders to make the mounting frame fit the frame mounting bracket.

Make sure to place the mounting frame on the frame mounting bracket. Ensure that the axle of your bike stays within the four triangles (located on top of the mounting frame).

Use the Allen wrench to tighten the hooks (clockwise). This firmly attaches the mounting frame onto the frame mounting bracket.

Good job: the mounting frame is now firmly attached to the frame mounting bracket. Get the bicycle seat for the most important step: attaching the Urban Iki bicycle seat to your bicycle.

1. Take the safety buckle in one hand and place your other hand on the clip at the bottom of the rear seat. Make sure the safety strap is located on top of the seat.
2. Slide the seat horizontally over the frame, and make sure to keep the seat centered.
3. Apply pressure to the top of the back and keep pushing down until you hear a ‘click’. Note: the seat is correctly attached when the red sticker above the clip is no longer visible!
4. Check if the seat is securely attached by shaking it back and forth.
5. Secure your bike seat against theft by turning and removing the key. Note: Only our latest bike seats (from March 2024 onwards) are equipped with an integrated lock with a key.

Now that the seat is securely in place, adjust the footrests to the correct height by lifting the levers at the back of the leg parts.

The shoulder straps can be adjusted to two heights and tightened or loosened using the buckles.