Mounting guide
Rear seat with frame mounting
Step 1: Slide the cover off the mounting block
Push down on the tab on the mounting block and slide the cover off.
First, we are going to assemble the Urban Iki rear seat. Take the two leg protectors and slide them into each other until they are securely attached. Then put the rear seat on its back, let the cable dangle and slide the leg sections into the slots on either side of the rear seat. When you hear ‘click’, this means the leg protectors are firmly attached.
Well done, your Urban Iki bicycle seat is assembled. Now we are going to attach the seat to your bicycle. Keep the following things within reach: the frame mounting bracket, frame mounting block with screws, mounting frame, Allen wrench, and of course your bicycle.
Push down on the tab on the mounting block and slide the cover off.
First, place a washer around each bolt (four in total) and make sure the covers under the mounting block are closed. Then insert the bolts into the four designated holes on the top of the mounting block.
Slide the mounting block over the frame of your bicycle. The iron plate should be placed against the bolts. Place a dowel over the bolts and tighten the bolts (clockwise) with the Allen wrench.
Slide the cover back onto the mounting block (from top to bottom) until you hear a ‘click’.
Now that the mounting block is securely attached to the frame of your bicycle, you can insert the frame bracket into the mounting block. Place the bracket in the designated holes on the backside. Please note: only when you hear a clear ‘click’, the frame mounting bracket is securely in place!
Now it’s time to mount the Urban Iki bicycle seat on the frame bracket. Keep the assembled rear seat, mounting frame, and Allen wrench at hand.
Use the Allen wrench to loosen the hooks on the mounting frame. After loosening, you can slide the holders to make the mounting frame fit the frame mounting bracket.
Make sure to place the mounting frame lengthwise on the frame mounting bracket. The front two hooks of the mounting frame should be positioned exactly above the axle of your back wheel.
Use the Allen wrench to tighten the hooks (clockwise). This firmly attaches the mounting frame onto the frame mounting bracket.
Good job: the mounting frame is now firmly attached to the frame mounting bracket. Get the bicycle seat for the most important step: attaching the Urban Iki bicycle seat to your bicycle.
First enter the code ‘000’; then press and hold the two sides of the lock; then set your personal three-digit code and release the buttons. Now the lock can only be opened with your personal code! To open the lock, enter your personal code, press the two sides of the lock and disconnect the cable.
Wrapping the cable around the frame prevents it from getting in the way. To close the lock, insert the cable into the lock until you hear a ‘click’. Now it’s tightly locked.
The Urban Iki bicycle seat is easy to detach. This allows you to cycle without a seat when you go out without your child.
Use your personal code. Enter the digits, press the two sides of the lock and disconnect the cable. Make sure that the cable is no longer around the frame tube. Then close the lock again so that the two parts do not dangle under the seat.
Grab the bicycle seat by the buckle (together with the cable of the lock), press the clip downwards and slide the disc at the bottom backwards in order to remove the seat from the mounting frame. It’s that simple!
Press the square black cap of the frame mounting block slightly down to remove the frame mounting bracket.